Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
movements (1 metre). Then, it will return to the starting point in spiral movements again.
-
Before operating the robot with Spot cleaning mode, place it on the spot to be cleaned.
-
Press the spot cleaning button in the app. Fig. 27
Edge mode
-
When this mode is selected, the robot will clean along walls and around furniture (e.g.
table or chair legs).
-
Press the border button in the app. Fig. 28
Room mode
-
The robot will carry out a 30-minute cleaning cycle when this mode is selected.
-
Press the room mode button in the app. Fig. 29
-
To ensure an efficient cleaning of the room, close the door.
Suction power level function
Select the power level in the app to control the robot's suction power during cleaning processes.
There are 3 suction power levels: Turbo, Normal and Eco. Fig. 30
Scrubbing intensity function
Select the scrub intensity in the app to control the water level during scrubbing. There are 3
water levels: High, Medium or Low.
Cleaning scheduling
-
This robot includes schedule settings in order for you to customize the cleaning cycles.
Programming can only be carried out via the app.
Setting cleaning schedule
-
To make cleaning easier, the robot has a function that allows it to be programmed daily
from the app. In accordance to the configuration, the robot will automatically start cleaning
the selected days at the desired time.
4. CLEANING AND MAINTENANCE
In order to lengthen your robot's shelf life and to allow your robot to operate at peak
performance, carry out the following procedures periodically.
-
Empty the robot's dust tank.
-
Press the dust tank's release button. Fig. 31
-
Open the dust tank and empty it. Fig. 32
44
Robot filter cleaning
-
Remove the filter.
-
Carefully shake off all dust from the filter. Fig. 33
Free-fall sensors cleaning
Use a clean, dry and soft cloth to wipe off any dust from the free-fall sensor located on the
right side of the robot's bottom part.
Warning
Do not spray cleaning products directly on the sensor. Fig. 34
Main brush cleaning
-
Slightly press the main brush frame's tabs in order to open the main brush storage
compartment and to remove it. Fig. 35
-
Remove any hair, fluffs or dust collected in the brush and around the axes. Fig. 36
-
Clear and clean the robot's suction channel. Fig. 37
-
Reinstall the main brush and its frame. Fig. 38
High-efficiency filter
-
The high-efficiency filter is designed with fibres that help trapping dust particles, dust
mites, pollen... It is very important to clean periodically the filter, to avoid these particles
from building up in the filter, causing efficiency loss. It is convenient to carry out this
maintenance once a week.
-
It is suggested to replace the filter by a new one after a maximum of 160 hours of use.
Recommendation
Dirt can be removed with a small brush or by shaking it carefully against a hard surface for
dust to fall off. The high-efficiency filter cannot be washed.
Mesh primary filter and sponge filter
The filtering system is featured with a mesh primary filter and a sponge filter. It is suggested
to replace them either after a maximum of 160 hours of use or when they are worn out due to
operation.
Recommendation
Dirt can be removed with a small brush or by shaking it carefully against a hard surface for
dust to fall off. You can also use warm water without detergents to obtain better results.
Always make sure they are completely dry before installing them again.
ENGLISH
45
Publicidad
