LaserLiner DigiLevel Laser G40 Manual Del Usuario página 12

Press button (2) again to deactivate the angle reference.
!
The angle reference is not deactivated by switching off
the device.
6
°C / °F / measured value
The ambient temperature is shown in °C and °F by briefly pressing
the CAL button (3). Press again to switch back to the measured
value.
7
HOLD
Press the HOLD button (5) to hold the current measured value
on the display.
8 Acoustic signal
The acoustic signal can be switched on or off with button (6).
When the angle of slope stands at 0°, 45°, 90° or the most recently
stored value, this is indicated by an acoustic signal.
!
When working with a changed angle reference value, the
acoustic signal is activated on reaching the new reference
value (0°, 45°, 90° display).
9 Backlighting
The backlighting is switched ON/OFF by pressing and holding button (6).
Auto Off function
In order to preserve the batteries, the measuring device switches off
automatically if it is left idle for 3 minutes.
Information on maintenance and care
Clean all components with a damp cloth and do not use cleaning
agents, scouring agents and solvents. Remove the battery(ies)
before storing for longer periods. Store the device in a clean and
dry place.
Calibration
The meter needs to be calibrated on a regular basis to ensure
it produces accurate measurement results. We recommend
carrying out calibration once a year. Contact your distributor
or the UMAREX-LASERLINER service department.
12
EN