Publicidad
Idiomas disponibles
Idiomas disponibles
−
If an indirect refrigerating circuit is being used, the secondary circuit shall
be checked for the presence of refrigerant;
−
Marking to the equipment continues to be visible and legible. Markings
and signs that are illegible shall be corrected;
−
refrigeration pipe or components are installed in a position where they
are unlikely to be exposed to any substance which may corrode
refrigerant containing components, unless the components are
constructed of materials which are inherently resistant to being corroded
or are suitably protected against being so corroded.
9. Checks to electrical devices
Repair and maintenance to electrical components shall include initial safety
checks and component inspection procedures. If a fault exists that could
compromise safety, then no electrical supply shall be connected to the circuit
until it is satisfactorily dealt with. If the fault cannot be corrected immediately
but it is necessary to continue operation, an adequate temporary solution shall
be used. This shall be reported to the owner of the equipment so all parties are
advised.
Initial safety checks shall include:
−
those capacitors are discharged: this shall be done in a safe manner to avoid
possibility of sparking;
−
that there no live electrical components and wiring are exposed while
charging, recovering or purging the system;
−
that there is continuity of earth bonding.
SAVE THESE INSTRUCTIONS
FOR HOUSEHOLD USE ONLY
Description of the appliance
1. Handle
3. Display window
5. Continuous drain
7. Power cord storage socket
2. Control panel
4. Water tank
6. Winding bracket
8. Air outlet
7
Publicidad
