Create HUM IZEN PRO Manual Del Usuario página 9

• First operation: Put the humidifier in the room temperature for half an hour before running.
• It is recommended to use the humidifier under a temperature of 20°C, relative humidity
less than 80% RH.
• Use clear water not over 40°C.
• Check the water tank, make sure it is clear.
1. Put the humidifier on a flat surface.
2. Remove the top cover, fill water into the water tank, and then put back the top cover.
Or take out the water tank for filling water, afterwards put the water tank back on the
main base.
3. Check if the rated voltage meets the input voltage, and plug into the socket. Then the
display will light up and the buzzer will ring for once. 1 second later, the display turns off,
only red symbol POWER
4. Touch the symbol POWER
light up meanwhile. Humidifier will begin to work in AUTO mode, with display show-
ing AUTO symbol and current humidity. 10 seconds later, the display shows current
temperature, and then changes into humidity. Temperature and humidity showing will
switch once in every minute.
• Humidifier will decide running humidity based on current temperature as below table.
Temperature of the air,
degrees Celsius
Humidity (%)
5. Constant Humidity: Touch the symbol HUMIDITY , you may select the humidity range
from 30% RH to 75%. Touch once, it will increase by 5% RH for each time. When it
reaches 75%, touch again, it will show "--" and humidifier will run back to AUTO mode.
6. After setting the expected humidity, humidifier will keep the memory and confirm by
flashing in 3 seconds. Once the display switches to show current humidity, it means
setting is finished, "%" on display will flash slowly.
• When setting humidity is 1% RH ~ 9% RH higher than current humidity, mist output
speed will run by the lowest (the first) speed.
• When setting humidity is 10% RH ~ 15% RH higher than current humidity, mist output
speed will run by the middle (the third) speed.
• When setting humidity is 15% RH higher than current humidity, mist output speed will
run by the highest (the fifth) speed.
• When current humidity is higher than setting humidity, humidifier will turn into sleep
state. Once current humidity is 3% RH lower than setting humidity, humidifier will re-
work in previous working mode till water shortage.
Mist output speed is adjustable under constant humidity function.
7. Night Mode: Long press symbol HUMIDITY
indicator light and display, only red ON/OFF symbol is showing. Press any symbol to
wake up the light and display.
8. Timer: There are 12 timer setting: 1,2,3,4,5,6,7,8,9,10,11,12 hours. Touch the symbol TIM-
ER , the LED display will show the timer setting from 01-12 in sequence, for example
"1H". Once finished setting excepted timer, without operation for 3 seconds, the timer
stop flashing means that the timer setting is successful.
OPERATION INSTRUCTIONS
showing and the humidifier is in standby state.
, display background and water tank indicator light will
≤19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 ≥37
65 60 58 57 55 53 50 48 45 43 40 38 36 35 34 32 31 30 25
for 2 seconds to shut down water tank
E NGLI SH
9