Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
TEMPERATURE & PRESSURE RELIEF VALVE
CLOSED SYSTEM THERMAL EXPANSION: Periodic discharge of the relief valve or
During the heating cycle of the water heater, the heated water expands causing
hot water under these conditions that result in a loss of energy and a build up
2. Install a 125-PSI pressure relief valve in the cold water supply line. Make sure
water heater (150 psi).
Note
the one provided with your purchase, please ensure that the maximum PSI
marking on the valve DOES NOT exceed the marked maximum working
pressure of the water heater.
at the top of the water heater.
not cap or plug the end of the discharge pipe.
PLEASE NOTE: MINI TANKS ARE FOR INDOOR PERMANENT INSTALLATIONS ONLY.
AND ALL AIR IS
REMOVED.THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. PLEASE VISIT SUPPORT.ECCOTEMP.COM FOR MORE INFORMATION.
Support: Support.Eccotemp.com
BEFORE POWERING THE WATER HEATER, BE SURE THAT THE SYSTEM IS COMPLETELY FILLED WITH WATER
Shop Online: www.Eccotemp.com
Phone: 866-356-1992
Designed in
Summerville, SC
10
Publicidad
