Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
TEMPERATURE & PRESSURE RELIEF VALVE
A discharge line should be installed and exit only 6 inches above, or at any
IMPORTANT: Failure to provide dielectric insulation may result in premature
tank or nipple failure and may void your warranty. The T&P valve is for
servicing and the valve should be in the open position when the water
heater is in operation. DO NOT APPLY HEAT DIRECTLY TO INLET OR OUTLET
CONNECTIONS.
Installed
Installing the T&P Valve Discharge Pipe:
have
2. Must NOT be plugged or blocked.
4. Must not be over 15 inches in length.
Wall
Anchor
PLEASE NOTE: MINI TANKS ARE FOR INDOOR PERMANENT INSTALLATIONS ONLY.
AND ALL AIR IS
REMOVED.THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. PLEASE VISIT SUPPORT.ECCOTEMP.COM FOR MORE INFORMATION.
11
Support: Support.Eccotemp.com
Temperature
Free Standing on Floor
any reducing couplings.
BEFORE POWERING THE WATER HEATER, BE SURE THAT THE SYSTEM IS COMPLETELY FILLED WITH WATER
Shop Online: www.Eccotemp.com
elbows.
Wall Mounte
Phone: 866-356-1992
Publicidad
