Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING UP
(1) Remove all the contents from the box and check you have all parts
specified. Make sure you recycle the inner and outer boxes after use.
(2) Simply push the floss tip into the slot at the top of the water flosser, until
it clicks into place. To eject, press the floss tip release button on the back of
the water flosser, then pull the floss tip out.
(3) Before using your water flosser, you should charge it for 6 hours. Open
the USB-C port cover, then plug in the USB-C connector of the charging
cable. Connect the USB-A connector to a power source. Ensure the water
flosser is not on prior to charging.
MAKE SURE THE USB-C PORT IS DRY BEFORE CHARGING!
(4) During the charging cycle, the lights on the mode indicator panel will
follow a sequence as shown in the diagram, to indicate the water flosser's
charging status. When the coloured light turns green, the water flosser is
fully charged. A full charge will last 30 days when using the water flosser
for 2 minutes each day.
(5) Once you have charged the water flosser, remove the USB-C charging
cable and securely close the cover. Make sure that this is closed properly to
avoid water getting inside.
(6) For travel convenience, you can store your Premium Clean floss tips
inside the water tank, as shown in the diagram. Simply push the water tank
release button at the top of the water tank and slide off. Inside you will find
two slots to securely store your Premium Clean floss tips. To reattach the
tank, slide back onto the main body until it clicks into place.
4
Publicidad
