Publicidad
Idiomas disponibles
Idiomas disponibles
CHARGING & MAINTAINENCE
(1) At 30% battery, all the lights on the mode indicator panel will flash 5
times after use. When the water flosser has no power, the lights will also
flash 5 times, but the device will not turn on – you need to recharge to a
sufficient level before you can continue using the water flosser.
(2) To clean the water tank, first remove it from the main body by pressing
the release button at the top of the tank and sliding off. Remove the base
from the tank by pushing the release button at the bottom and pulling open.
You can clean all parts of the tank with warm, soapy water or place in the
dishwasher.
(3) To clean the main body of the water flosser, ensure it is switched off
and disconnected from any power source. We recommended activating the
Lock Mode for cleaning. To avoid scratching, use a soft, dry or damp cloth
to clean the main body.
(4) To clear hard water deposits from within your water flosser, fill the tank
with water and add 1 tablespoon of white vinegar. Run the water flosser
until the tank is empty, then rinse thoroughly with clean, warm water. Repeat
this process every 1 to 3 months, depending on the hardness of your water.
(5) It is recommended that you replace floss tips when they become
worn or dirty, this is usually every 6 months. Replacement tips as well as
Orthodontic and Periodontal tips are available at ordolife.com
6
Publicidad
