Dometic 9600023469 Instrucciones De Montaje Y De Uso página 15

Rollerblind Powered
11 Troubleshooting
Fault
Guide wire tension too low
Guide wire too short
Guide wire broken
Motor not working
Guide wire or side track blind not running
smoothly
Side track not vertical
Fabric rolls off sides of ends of roller
Blind stops in wrong position
Different blinds running at different speeds
Blind does not work
EN
Solution
➤ See chapter "Fitting the guide wire ver-
sions" on page 11.
➤ Order replacement guide wire, see
spares leaflet at dometic.com.
➤ Order replacement guide wire, see
spares leaflet at dometic.com.
➤ Check if wiring for voltage to the motor is
correct.
➤ If power supply is checked and the motor
is still faulty contact your distributor.
➤ If using the AP Remote control refer to the
AP Remote control manual.
➤ Check restraint positions and recess
dimensions.
➤ Check if the side tracks are fitted perpen-
dicular to the roller and parallel to each
other.
➤ Check if the guide wires or side tracks are
perpendicular to the roller and that the
roller is horizontal.
➤ Refer to manual of your control device
(e.g. AP Remote control).
➤ Refer to manual of your control device
(e.g. AP Remote control).
➤ Check the power supply to the blind.
Prolonged or repeated use can activate the
built-in thermal cut-out.
➤ Leave the motor to cool for 20 min and
try again.
If using an AP Remote control:
➤ Refer to the AP Remote control manual.
Troubleshooting
15