Tennant IPC Kosmic-H Manual De Instrucciones página 29

B B
FIG. 9
FIG. 10
the electric motor overheats.
WATER CIRCUIT CONNECTION
Connect the feed hose to the mains (fig. 9A) and to
the hosetail on the cleaner (fig. 9B).
Check that the pressure and quantity of the water
supplied by the mains are sufficient for the cleaner
to work properly: 0,2 ÷ 0,8 MPa. (2 ÷8 bar) (29÷116
PSI).
Maximum temperature of feeding water 50°C
(122°F).
Connect the high pressure hose to the cleaner (fig.
9C) and to the lance (fig. 10).
Danger
The cleaner must operate with clean water. Dirty or
sandy water, corrosive chemicals and solvents can
cause severe damage to the cleaner.
Danger
Never suck up liquids containing solvents or acids in
the pure state, for example petrol, paint solvents or
diesel. The spray mist from the lance is highly inflam-
mable, explosive and poisonous.
Failure to respect the above absolves the manu-
facturer of all liability and represents negligent use
of the product.
Respect the instructions provided by the water utility
company.
Current regulations specify that the appliance may
not be connected to the drinking water supply unless
C C
a suitable system separator is fitted.
Use a suitable EN 12729 type BA system separator.
Water passing through a system separator is no lon-
ger classified as drinking water.
A A
Do not connect the machine to a drinking water con-
tainer.
Failure to comply with the above releases the manu-
facturer from liability and constitutes negligent use
of the product.
ELECTRICAL CONNECTION (fig. 4)
The water cleaner must be connected to a mains
electricity supply conforming to current legislation
and standards.
Ensure that the mains voltage available is the same
as the voltage at which the cleaner is supposed to
work; this is indicated on the identification plate.
- The electric cable must be protected from acciden-
tal crushing.
- Do not use the machine if the supply cable is da-
maged.
- The use of any electric appliance requires the re-
spect of some basic rules:
• Do not touch the appliance with wet or damp hands
or feet.
• Do not use the appliance bare-footed or with unsu-
itable clothing.
• Do not pull the supply cable or the appliance itself
in order to disconnect the plug from the electric sup-
ply.
(For water cleaners rated at less than 3 kW fitted
with plug).
As for the protection against electric shock, the
H.P.cleaner belongs to CLASS I.
Failure to observe the above warning frees the
manufacturer from all responsibility and consti-
tutes negligent use of the product.
EN - english
Information
Warning
Danger
27