Tennant IPC Kosmic-H Manual De Instrucciones página 31

A A
FIG. 13
FIG. 14
FIG. 15
B B
USING THE ADJUSTABLE HEAD (Fig. 13)
To use the detergent solution, an extension wand
must be installed, fitted with adjustable head (sup-
plied as an optional accessory).
The adjustable head enables you to select a low or
high pressure jet. The pressure is selected by rota-
ting the head.
High pressure pos. A. Low pressure pos. B.
REGULATING PRESSURE
This chapter concerns only those models provided
with the "pressure regulating" device. The pressure
regulator, fig. 15, allows the operator to adjust the
working pressure. When knob C is turned in an an-
ti-clockwise direction (B) (minimum), the working
pressure is reduced.
USING COLD WATER
It is suitable for removing light dirt or for rinsing ope-
rations on garden tools, walls, balconies, hard floors
in general,etc.
Adjust water pressure according to your needs.
USING "ECO" MODE
In the "ECO" mode, the pressure washer uses tem-
perature up to 60°C, which offers an efficient use of
resources with a positive impact on the environment.
USING HOT WATER AND VAPOUR
For a correct use of the Hot Water and Vapour Mode
(if available), it's advisable to use the following tem-
peratures:
- Light dirt: 30 - 50 °C:
- Proteic dirt, e.g., in the food sector: 60 °C Max
- Cleaning Automobile or Machine Tools: 60 - 90 °C
- Debinding, Persistent greasy dirt: 100 - 110°C
- Facade cleaning, Sanitization of surfaces: up to
110 °C
With working temperature more than 95°C (203°F),
the pressure that indicates on the manometer must
be < a 3,2 MPa (32 Bar) (460 PSI).
EN - english 29