Trumpf TruTool TR-TF350-NC Manual Del Usuario página 20

EN
3.5 Tool for ventilation duct
construction
The "plate for channel" can be used option-
ally for joining flange profiles with the inser-
tion aid. Joints are only possible in the
lengthwise direction.
The stripper for the channel enables more
maneuverability in the channel.
1 Die arm
2 Joint lengthwise
3 Plate for channel
4 Stripper for channel
5 Flange on the channel
6 Punch arm
3.6 Slewing ring
You can use the slewing ring to optionally
swing the machine into different processing
positions, see Clamping the slewing ring
[} 318].
M
3.7 Joining station
WARNING
Risk of injury due to tipping over of
the joining station
u Anchor joining station firmly on the
floor.
The joining station can be used optionally for
stationary operation, see Clamping the join-
ing station [} 318].
N
20
1
2
3
4
5
6
Translation of the original operator's manual
4 Consumables and
accessories
4.1 Tool selection
For notes about the selection of the correct
tool, order specifications for wearing parts
and consumables, and accessories and
spare parts lists, see:
www.trumpf.com
TF 350 TF 350
(3A1) (3A5)
4.2 Alternative rechargeable
batteries
TF 350
(3A5)
This power tool can be used with all
CAS LIHD 18 V and CAS LI-Ion 18 V
rechargeable batteries up to a capacity of
8 Ah.
5 Maintenance
After 20 hours of operation, the power fas-
tener must be re-lubricated, see Lubricating
the ram [} 316] and Lubricating the cou-
I
pling [} 317].
J