Indesit IFW 6841 JP IX Guía Rápida página 23

MAINTENANCE
AND CLEANING
Do not use steam cleaning
equipment.
Use protective gloves during all
operations.
EXTERIOR SURFACES
Clean the surfaces with a damp microfibre cloth. If
they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
Do not use corrosive or abrasive detergents. If any of
these products inadvertently comes into contact with
the surfaces of the appliance, clean immediately with
a damp microfibre cloth.
INTERIOR SURFACES
• After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove any
deposits or stains caused by food residues. To dry any
condensation that has formed as a result of cooking
foods with a high water content, leave the oven to cool
completely and then wipe it with a cloth or sponge.
REMOVING AND REFITTING THE DOOR
1.
To remove the door, open it fully and lower the
catches until they are in the unlock position.
2.
Close the door as much as you can.
Take a firm hold of the door with both hands – do
not hold it by the handle. Simply remove the door by
continuing to close it while pulling it upwards (a) at
the same time until it is released from its seating (b).
~60°
Put the door to one side, resting it on a soft surface.
3.
Refit the door by moving it towards the oven,
aligning the hooks of the hinges with their seating
and securing the upper part onto its seating.
4.
Lower the door and then open it fully.
Lower the catches into their original position: make
sure that you lower them down completely.
5.
Try closing the door and check to make sure that it
lines up with the control panel. If it does not, repeat
the steps above.
WWW
Carry out the required
operations with the oven cold.
Disconnect the appliance from
the power supply.
If there is stubborn dirt on the interior surfaces, we
recommend running the automatic cleaning function
for optimal cleaning results.
• The door can be easily removed and refitted to
facilitate cleaning of the glass
• Clean the glass in the door with a suitable liquid
detergent.
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot. Food residues can be removed using a
washing-up brush or a sponge.
CLICK & CLEAN - CLEANING THE GLASS
1.
After removing the door and resting it on a soft
surface with the handle downwards, simultaneously
press the two retaining clips and remove the upper
edge of the door by pulling it towards you.
2.
Lift and firmly hold the inner glass with both
hands, remove it and place it on a soft surface before
cleaning it.
3.
~15° Refit the intermediate pane (marked with "1R")
before refitting the inside pane: To position the panes
b
of glass correctly, make sure that the "R" mark can be
seen in the left-hand corner. First insert the long side
of the glass marked "R" into the support seats, then
lower it into position. Repeat this procedure for both
a
panes of glass.
4.
Refit the upper edge: a click will indicate correct
positioning. Make sure the seal is secure before
refitting the door.
Download the Use and Care Guide from
docs . indesit . eu for more information
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
.
WWW
EN