BYK byko-spectra standard Instrucciones De Uso página 9

BYK-Gardner GmbH
Step 2
Attach the rear panel (D) to the left and right side frames and to the viewing surface using
five (5) screw and washer assemblies. Locate five (5) gray decorative caps and snap them
onto the screw and washer assemblies (in rear of booth) to conceal the screw heads.
Step 3
Attach the luminaire to the upper framework by aligning the slots of the luminaire with
the mounting studs in the upper portion or the side frames and gently dropping the fix-
ture into place. The luminaire is correctly positioned when the switchboard is located to-
wards the front of the unit (as shown below).
Step 4
To attach the side walls, first, partially loosen the screws holding the rear panels and view-
ing surface in place. Insert each panel (making sure that the folded channels are facing out
and forward) by sliding them between the side frames and the viewing surface, at the bot-
tom, the side frames, and the luminaire, at the top, and the side frames and the rear pan-
els, at the rear. When installed correctly the "V" notches in the side panels will line up
with the screws holding rear panels. Retighten the screws holding the rear panels and
viewing surface in place.
NOTICE
There may be reasons to use the light boot without side walls, such as viewing objects
wider than the boot.
184 020 846 EDFS 2402
byko-spectra standard
9