Publicidad
Idiomas disponibles
Idiomas disponibles
13
GB
DIP-SWITCH
st
1= ON 1
pair of Photocells stop gates during opening
2= ON Radio does not invert during opening
3= ON Closes in Automatic mode
4= ON Pre-flashing of flashing light
5= ON Step-by-step by radio with intermediate stop
6= ON Single pedestrian when gate is closed
7= ON Stroke reversing pulse function enabled when opening from closed gate position
8= ON Eliminates the Leaf delay when opening. The motors start together
LOW VOLTAGE ELECTRICAL CONNECTIONS
Photocells
The 1st pair of Photocells (device installed on gate posts) is managed by Dip-Switch 1
:
The 2nd pair of photocells (device installed inside entrance) stops during opening and changes direction when closing once the
obstacle has been removed
1
2
Pushbutton
Key switch:
switch:
Radio contact:
- Open/Close (normal) changes direction at each pulse
- Step-by-step with intermediate stop
Electric lock:
Mechanical accessory that locks the gate in closed position, recommended for installation with leaves over 1.80 m in length and
Operating time: power supply for 2 seconds, 100ms in advance before leaf movement starts
24V 3W Indicator light showing leaf in movement:
1643
Drwg. No.
exp
230V SINGLE-PHASE PROGRAMMER FOR SWING GATE OPERATORS
1
2 3
4 5 6 7 8
OUTPUT 24Vac(MAX. LOAD:
2 pairs of PHOTOCELLS
1 RADIO RECEIVER)
4
3
5
6
7
3
10
9
8
11
ON
OFF
1
2
3
4
5
7
8
6
9
10
12 13
DIP-SWITCH 1 (only for 1st pair of Photocells):
ON: Photocell stops gate on opening and changes direction
1
OFF: Photocell no stop on opening and changes direction
DIP-SWIT CH 2:
ON: Does not change direction
during opening
2
OFF: Changes direction at each pulse
DIP-SWIT CH 5:
ON: Step-by-step with intermediate stop
OFF: Normal operation
5
Indicator light On = Gate open
Indicator light Off = Gate closed
0.5s flashing (fast) = closing movement
1s flashing= opening movement
11 12 13 14 15
when closing once the obstacle has been removed
when closing in case of an obstacle
non locking operators.
7
7
Publicidad
