Publicidad
Idiomas disponibles
Idiomas disponibles
FLUSHING INSTRUCTIONS
IMPORTANT: Pipe chips, sand, stones and other solids found in new and renovated
plumbing can damage the sealing surfaces of the cartridge and cause leaks. To avoid
damage, DO NOT TURN ON SUPPLY VALVES until instructed below:
1. After installing and connecting your new faucet, turn on in the full cold position
(handle pointing to the right) and turn on the cold supply for 15 seconds.
2. Without closing the handle, turn to the full hot position (handle pointing to the left)
and turn on the hot supply for 15 seconds.
3. Close the handle, then using a towel unscrew the aerator from the end of the spout
and clean the aerator.
4. Using a towel replace the aerator and check the system for leaks.
DISASSEMBLY (LEVER)
4
1
1
5
6
2
3
1. Remove red/blue plug button (3),
from front of lever handle, remove
set screw (2) and lever handle (1).
Unscrew handle screw (4) and lift off
the handle adapter (5) (with handle
connector (6) attached).
CAUTION: Be careful not to damage the rubber seals when re-installing cartridge. During installation be sure of the following:
• Stem must be in open position
• Position ears front to back
• Notched flat on stem faces toward front of faucet
• Retainer clip straddles ears
MOEN LIFETIME LIMITED WARRANTY
Moen products have been manufactured under the highest standards of quality and workmanship.
Moen warrants to the original consumer purchaser for as long as the original consumer purchaser
owns their home (the "Warranty Period" for homeowners), that this faucet will be leak and drip-free
during normal use and all parts and finishes of this faucet will be free from defects in material and
manufacturing workmanship. All other purchasers (including purchasers for industrial, commercial and
business use) are warranted for a period of 5 years from the original date of purchase (the "Warranty
Period" for non-homeowners).
If this faucet should ever develop a leak or drip during the Warranty Period, Moen will FREE OF
CHARGE provide the parts necessary to put the faucet back in good working condition and will replace
FREE OF CHARGE, any part or finish that proves defective in material and manufacturing
workmanship, under normal installation, use and service. Replacement parts may be obtained by
calling 1-800-289-6636 (Canada 1-800-465-6130), or by writing to the address shown. Proof of
purchase (original sales receipt) from the original consumer purchaser must accompany all warranty
claims. Defects or damage caused by the use of other than genuine Moen parts are not covered by
this warranty. This warranty is applicable only to faucets purchased after December 1995 and shall be
effective from the date of purchase as shown on purchaser's receipt.
This warranty is extensive in that it covers replacement of all defective parts and finishes. However,
damage due to installation error, product abuse, product misuse, or use of cleaners containing
abrasives, alcohol or other organic solvents, whether performed by a contractor, service company, or
yourself, are excluded from this warranty. Moen will not be responsible for labor charges and/or
damage incurred in installation, repair or replacement, nor for any indirect, incidental or consequential
damages, losses, injury or costs of any nature relating to this faucet. Except as provided by law, this
warranty is in lieu of and excludes all other warranties, conditions and guarantees, whether expressed
or implied, statutory or otherwise, including without restriction those of merchantability or of fitness for
use.
Some states, provinces and nations do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitations or exclusions may not apply to you. This warranty
gives you specific legal rights and you may also have other rights which vary from state to state,
province to province, nation to nation. Moen will advise you of the procedure to follow in making
warranty claims. Simply write to Moen Incorporated using the address below. Explain the defect and
include proof of purchase and your name, address, area code and telephone number.
3
2
8
7
2. Remove ring shield (8). Unscrew the
pivot retainer (7).
For reassembly reverse the steps above. Be sure that pivot retainer
is rotated 1/4 turn past hand tight.
TROUBLESHOOTING
TO CORRECT REVERSED HOT AND COLD POSITIONS:
1. Position handle so that it points toward you.
"Disassembly").
2. Turn cartridge stem around so that the notch
is turned one half turn or 180°.
3. Re-install handle in the same position that it
was in when you took it off (pointed directly
toward you). Tighten handle screw securely
and replace plug button.
9
3
1
14
11
3. Remove washer (9), collar (10) and
the retainer clip (14). Lift off the stop
sleeve (11).
CONSUMER INFORMATION
Faucets made of leaded brass alloys may contribute small amounts of lead to
water that is allowed to stand in contact with the brass. The amount of lead
contributed by any faucet is highest when the faucet is new. The following steps
may reduce potential exposure to lead from faucets and other parts of the
plumbing system:
• Always run the water for a few seconds prior to use for drinking or cooking
• Use only cold water for drinking or cooking
• If you wish to flush the entire plumbing system of water that has been standing
in the pipes or other fittings, run the cold water until the temperature of the
water drops, indicating water coming from the outside main
• If you are concerned about lead in your water, have your water tested by a
certified laboratory in your area
In the U.S. call our toll free Helpline number for answers
to any product, installation, or warranty questions.
Moen Incorporated • 25300 Al Moen Drive • North Olmsted, OH 44070-8022 U.S.A.
In Canada Moen Inc. • 2816 Bristol Circle • Oakville, Ontario L6H5S7
Remove handle parts (see
NOTCHED
FLAT ON
TURN STEM
STEM
1/2 TURN
4
13
12
4. (NOTE: Check the position of the
cartridge to aid proper replacement).
Using pliers, pull the cartridge (13)
out of the faucet body by the stem
as shown above. Remove washer
(12).
EAR
CLIP
NOTCH
HELPLINE:
1 (800) BUY-MOEN
[289-6636]
In Canada:
Toronto: 905-829-3400;
Rest of Canada: 1-800-465-6130
In Mexico:
(84) 88-08-26, 88-08-27,
o 91-800-84-345
INS319
Publicidad
