Lighted SERPIS Manual De Instrucciones página 15

2. INSTALL THE SUSPENSION SYSTEM
(1). Remove the clevis pin from the fan. Pass the down rod through the upper and lower
canopies to connect to the fan motor assembly. Insert the wires to the down rod. Make sure that
the holes of down rod are aligned with the holes of the joint. Insert the bolt and pass "R" pin
through the clevis pin hole. Then lock the down rod with screws. (Fig.4).
(2). Lift the fan assembly onto the mounting bracket. Rotate the fan until the notch on down rod
ball engages with the slot of the mounting bracket. (Fig.5-6)
Dpto. Comercial / Marketing
pedidos@algsa.es
15
MANUAL DE INSTRUCCIONES
INSTRUCTIONS MANUAL