IKRA IEG 2500 Manual De Instrucciones página 22

15. EC Declaration of Conformity
We, Ikra GmbH, Schlesierstraße 36, D-64839 Münster,
Germany, declare under our sole responsibility that the
product Electric Silent Shredder IEG 2500, to which
this declaration relates correspond to the relevant basic
safety and health requirements of Directives 2006/42/
EC (Machinery Directive), 2014/30/EU (EMC-Guide-
line), 2011/65/EU (RoHS-Guideline) and 2000/14/EC
+ 2005/88/EC (noise directive) incl. modifications. For
the relevant implementation of the safety and health
requirements mentioned in the Directives, the following
standards and/or technical specification(s) have been
respected:
EN 60335-1:2012; EN 13683/A1:2009+A2:2011
EN 62233:2008; EN 50581:2012
AfPS GS 2014:01 PAK
EN 55014-1/A1:2009/A2:2011; EN 55014-2/A2:2008
EN 61000-3-2:2014; EN 61000-3-11:2000
measured acoustic capacity level
guaranteed acoustic capacity level
Conformity assessment method to annexe V / Directive
2000/14/EC
The year of manufacture is printed on the nameplate and can be ad-
ditionally retrieved via the consecutive serial number.
Münster, 01.11.2018
Matthias Fiedler, Technical Management Ikra GmbH
Maintenance of technical documentation:
Matthias Fiedler, Schlesier Strasse 36, DE-64839 Münster
16. Troubleshooting
PROBLEM
Motor does not run
The material is not being pulled in
GB | Operating Instructions
108 dB (A)
111 dB (A)
CAUSE
Safety lock
Power outage
The material is clogging up in the
feeding funnel.
The shredding material is too soft.
The blade is blocked.
GB-9
SOLUTION
Tighten the hand screws well.
Check the power supply cable, the
plug and the fuse.
Shut down the shredder. Pull the
material out of the feeding funnel.
Restart the shredder and insert the
thick branches in such a way that
the blade does immediately catch
in the previous cut.
Put some wood in or shred dried
branches.
Unscrew the hand screw. Open the
shredder and remove the material
causing the clog.