GE PP9830 Manual Del Propietario E Instalación página 8

or)
L_
(D
C
!.
03
(b
U
ED
!.
oO
O
I--
O
O
U
I.U
I
Z
Surface Burners (Cont.)
Dual Surface Unit
The right front surface unit has 2 cooking sizes to select
from so you can match the size of the unit to the size of
the cookware you are using.
To use the large (9dnch) surface unit, turn the knob
clockwise to El and select the desired setting. The unit
will heat the entire area contained by the larger circle.
To use the small (6-inch)
surface unit, turn the knob
counterclockwise to I:1 and
select the desired setting. The
unit will only heat the area
inside the smaller circle.
Small 6" -€_O @
surface unit Large 9"
setting surface unit setting
Bridge Surface Unit
Make sure the pan rests flat on the glass cooktop and
it is not resting on the trim. If you notice poor cooking
performance, move the pan to make sure it is flat on
the cooktop.
To use the bridge burner, turn the burner knob to El and
select the desired setting. The unit will heat the front
surface burner and the bridge.
Choose pans that match the circle/bridge area as closely
as possible.
To use only the front surface
unit, turn the burner knob to [I_
and select the desired setting.
The unit will only heat the front
surface burner.
You can create an oblong
heated area by using the left
rear unit in addition to the front
unit bridge combination.
Front
Burner-}_ Front ----I_
only Burner and v
Bridge
Surface Elements Cycle On and Off
Surface elements will cycle on and off to maintain the
temperature you have selected.
All radiant surface elements have a temperature limiter
that protects the glass cooktop from getting too hot.
The temperature limiter may cycle the elements off
while cooking if:
[] The pan boils dry.
[] The pan bottom is not flat.
[] The pan is off-center.
[] There is no pan on the element.
Temperature Limiter
Every radiant surface unit has a temperature limiter.
The temperature limiter protects the glass cooktop from
getting too hot.
The temperature limiter may cycle the units off for a
time if:
[] The cooktop is on while cooking.
[] The pan boils dry.
[] The pan bottom is not flat.
[] The pan is off-center.
[] There is no pan on the unit.
Control Lock-Out for Surface Units
To activate control lock-out, turn the Control Lock knob
to LOCK. This will prevent surface units from heating.
An indicator light will glow to show that they are locked.
The downdraft fan will remain operable with control
lockout engaged.
In the locked position, the cooktop CONTROL LOCK
UNLOCK
will produce an audible sound if any Lock "
surface unit control knob is engaged or /" Ill "_
moved to a position other than OFF.
\JlJ
How to Operate the Vent System
The built-in vent system helps remove cooking vapors,
odors and smoke from foods prepared on the cooktop.
To operate the downdraft vent system, turn the vent fan
speed control knob to HI, MED or LO, as needed.
Continuous use of the vent system while FA,
cooking helps keep the kitchen comfortable OFF
and less humid, reducing cooking odors if ill "_
and soiling moisture that normally creates a klll,,,,u/,.o
frequent need for cleaning.
49 80635 2