JENN-AIR JGD8130 Serie Manual De Instrucciones

CONVERTIBLEGAS GRILL
COOKTOPSERIES
JGD8130 & JGD8345
=JENN-AIR ,1
403 WEST FOURTHSTREET,NORTH • NEWTON,IA 5020
DIMENSIONS SHOWN IN BOTH INCHES AND CENTIMETERS
*Blower may be rotated for horizontal or vertical direction by loosening nuts around blower inlet. Accessible inside ventilation
chamber.
• NOTICE TO INSTALLER: Leave these instructions with the appliance.
• NOTICE TO CONSUMER: Retain these instructions for future reference.
TIE DOWN BOLT
ON EACHEND
BLOWERCAN BE GREASE
SWIVELED90° CONTAINER
,--I"1 29" + 1
, 73,66 cm
DUCTINGINSTALLA-
TION INSTRUCTIONS).
T 3 1/2"
8.8 cm
t
13 13/16"
35.1 cm
2 7/8"
7.3 crn
.Am_
REGULATOR
21" + 1/16"
53,34 cm
7 9/16"
19,21 cm
APPLIANCEPRESSURE
REGULATOR
TIE DOWN BOLT
ON EACHEND
GREASE
BLOWERCAN BE CONTAINER
SWIVELED90°
43 1/4" + 1/ 21" + 1/16"
_"_1 109.86 cm , 53.34cm
79/16"
1 7/8"
Min.
'l 15/16" 4,76 cm
Min.
Clearance
2.38 cm
3RIATE _"4f _ ._
(SEE---'
SELECTAPPROPRIATE
DUCTCUT OUT
DUCTINGINSTALLA-
GREASE TION INSTRUCTIONS).
CONTAINER GREASE
r II"
\_ "1_ ;l_ _ _
CONTA,NER
[ .
I II I[[F_]_'_'_'_APPL E ANCE
PRESSURE 13
FEGULATOR 35
.
3_.9 om _o.o oo 7237,8 L
INSTRUCTIONSTO INSTALLER
• Dimension "A" - Provide 2" min. (5.08 cm) cabinet clearance to motor for cooling purpose.
• Note - Where possible, 6" (15.24 cm) is recommended for motor/blower service.
• Side Clearance - Grills installed near a side wall must allow a minimum clearance of 8".
• Access must be provided to remove and empty grease container(s).
8101 P580-60
(04-04-00)