JENN-AIR JGD8130 Serie Manual De Instrucciones página 2

Installing Cabinetry Over Your Jenn-Air Grill
*A = 30" (76.2 cm) minimum vertical clearance between
cooking surface and construction above the
appliance.
*B = 13" (33.02 cm) maximum depth of cabinets installed
above cooking top.
t_ i_ mmm
A ÷
Dotted lines
indicate
range hood
construction
* To eliminate associated potential hazards such as
reaching over open flames, avoid use of cabinets above
cooktop for storage space.
Cabinets Above Cooking Top
Maximum depth of cabinets installed above cooking top is
13 inches.
CAUTION: SOME CABINETS AND BUILDING
MATERIALS ARE NOT DESIGNED TO WITHSTAND
THE HEAT PRODUCED BY THE NORMAL SAFE
OPERATION OF A LISTED APPLIANCE.
DISCOLORATION OR DAMAGE, SUCH AS
DELAMINA- TION, MAY OCCUR.
WARNING
THIS PRODUCTSHOULDNOT
BE INSTALLED BELOWA
VENTILATION TYPE HOOD
SYSTEMTHATDIRECTSAIR
IN A DOWNWARD DIRECTION.
(SEE FIGURE)
THESESYSTEMSMAYCAUSE
IGNITIONAND COMBUSTION
PROBLEMS WITH THE GAS
BURNERSRESULTINGIN
___j[_ PERSONALINJURYAND MAY
AFFECTTHE COOKING
PERFORMANCE OF THE UNIT.
ART # 9215-252
NOTE:THE FIGUREMAYNOT ACCURATELY REPRESENT
YOUR RANGEOR COOKTOP;HOWEVER, T HIS WARNING
APPLIESTO ALL GASCOOKINGPRODUCTS.
InstallationOf Appliance
Follow accompanying ducting instructions carefully.
This appliance is designed to always be vented outdoors.
The Countertop Cutout, Cabinet Front Cutout and Duct
Opening should be prepared according to the illustrations
on pages 1 and 2.
The installation of this appliance must conform with local
codes or, in the absence of local codes, with the latest
edition of the National Fuel Gas Code, ANSI Z223.1 USA
or current CAN/CGA-B149 INSTALLATION CODE.
This product must be installed by a licensed plumber or
gas fitter when installed within the Commonwealth of
Massachusettsl
A' T handle type manual gas va!ve must be installed in
the gas supply I neto this appliance.
A flexible gas connector; when used, must not exceed a
length of three (3)feet / 36 inches.
The electrical supply required is
110/120 Volt, A.C., 15 amp, 60
Hz. This appliance is equipped
with a grounded tpe power cord.
A grounded outlet must be pro-
vided. It is recommended, for
convenience, this outlet be lo-
cated in the area shown in the
shaded illustration (see figure 2).
Cabinet Bottom
Figure 2
User may experience occasional circuit tripping if Ground
Fault Circuit Interrupter (GFCl) outlet or breaker is in use.
This appliance, when installed, must be electrically
grounded in accordance with local codes or, in the
absence of local codes, with the latest edition of the
National Electrical Code ANSI/NFPA No. 70 USA or
current CSA STANDARD C22.1 Canadian Electrical Code
)art 1.
ELECTRICAL GROUNDING INSTRUCTIONS
IS EQUIPPED WITH
THREE,PRONG GROUNDING PLUG FOR YOUR
PROTECTION AGAINST SHOCK HAZARD
SHOULD BE PLUGGED DIRECTLY INTO A
PROPERLY GROUNDED RECEPTACLE. DO NOT
CUT OR REMOVE THE GROUNDING PRONG FROM
THIS PLUG. .........................
2