TO REMOVE
DUST BAG
!
WARNING
Always
unplug
power cord from
electrical
outlet before
performing
maintenance
to the vacuum
clean-
st.
Pull out on the
bag cover
release located
near the top of
the bag cover.
Bag Cover
O°"r-l
Bag
Pull the bag
cover forward
and lift up.
Remove and
lay aside.
Grasp the dust bag
collar and pull gen-
tly, carefully
remov-
ing the dust bag.
Throw away the
used dust bag.
Bag
Do not reuse
dust bag.
_
l
Bag Holder
Check the bag
holder and the
/_-_-_eagCavitymotorsafetyfil-
ter. if either is
blocked,
check
SHOOTING.
NEVER
REUSE
A DUST BAG.Very
fine materials,
such as carpet
freshener,
face powder,
fine dust,
plaster, soot, etc. can clog the bag
and cause
it to burst before
it is
full. Change
bag more often when
vacuuming
these
materials.
TO REPLACE DUST BAG
Unfold the
new dust bag.
Fold the safety
seal tab on the
new dust bag
away from the
opening that
fits on the bag
holder.
Dust
Bag
Note: See PARTS AND FEATURES
for
Bag number.
__
Insert the dust bag
onto the bag holder
completely by holding
the bag collar.
Place the dust bag
collar into position.
Tuck the bag
behind each of
the four bag
retention corner
flaps shown here.
Be sure the bot-
tom and sides of
the dust bag are
completely
within
bag cavity prior to
replacing
the bag
cover.
Bag
Retention
Comer
Flaps
Position the bag
cover so its
positioning
tabs
fit into the body
positioning
tab
slots.
Close the bag cover.
You will hear a
distinct snap
when cover is
securely
closed.
Bag
Check to see
that the dust
bag is fully
enclosed
in the
bag cover.
14