Kenmore 116.35622 Manual Del Propietário página 7

Toselecta pile height setting:
Turnoffvacuum
cleaner. Select a pile height
setting by tilting the vacuum cleaner back
until front wheels are lifted slightly off the
floor.
Slide the adjustment lever to the correct
setting.
There are tour (4) pile height settings on the
vacuum cleaner. Use the LOW setting for
most low-pile carpets and bare floor
cleaning (with agitator OFF), and the HIGH
setting for high-pile carpets like shag carpet,
scatter rugs, etc. Use the other settings as
needed for carpet heights in-between low
and high pile.
CAUTION
Do not allow vacuum cleaner to
remain in one spot for any length
of time when the agitator is turn-
ing. Damage to carpet may occur.
SOME MODELS
Bare floor setting: Slide the carpet/bare
floor selector all the way back and down
toward the bottom of the nozzle until it
locks into place.
In this position the brush assembly does
not revolve. This setting should be used
for cleaning hardwood and tile floors and
when any attachments (tools) are
used.
Carpet setting: Slide the selector all the
way forward and up to the carpet
position.
In this position the brush assembly will
turn. When carpets are being cleaned the
selector should be in this position.
Attention: Refer to your carpet manufac-
turers cleaning recommendations. Some
more delicate carpets may require that
they be vacuumed with the agitator turned
off, to prevent carpet damage.
!
CAUTION
Do not allow vacuum cleaner to
remain in one spot for any length
of time when the agitator is turn-
ing. Damage to carpet may occur.
Note: For longer belt life, turn the vacuum
cleaner off before moving selector, other-
wise make sure the selector is pushed
fully and quickly as possible to the
desired position. Failure to do so can
cause the belt to rub on the selector shaft
and may result in the belt becoming hot
and creating a burning rubber smell.
Carpet/Bare
Floor Selector
To Bare Floor
Position
To Carpet
Position
7