cecotec BOLERO AGUAZERO 4201 E Manual De Instrucciones página 76

ENGLISH
When to refill the rinse aid dispenser
Unless the rinse aid warning light on the control panel is on, you can always estimate the
amount from the colour of the optical level indicator "D" next to the cap. When the rinse aid
dispenser is full, the indicator will be fully lit. As the rinse aid diminishes, the light fades too.
Never allow the rinse aid level to be below ¼ of its capacity.
The size of the light changes on the rinse aid indicator as the rinse aid decreases.
Rinse aid optical level indicator (Fig. 5):
D (Rinse aid indicator)
Full
3/4 full
1/2 full
1/4 full - Should be refilled to eliminate stains.
Empty
1. To open the dispenser, turn the cap anticlockwise (to the open (left) arrow) and lift it out.
2. Pour the rinse aid in the dispenser, careful not to pour too much.
3. Replace the cap by inserting it alligned with the open arrow and turn it clockwise (to the
closed (right) arrow).
Fig. 6
Rinse aid is released during the last rinse to prevent water droplets from forming on the
-
dishes, which can leave stains and marks. It also improves drying as it allows water to
slide through the dishes. This dishwasher is designed to use liquid rinse aids. The rinse
aid dispenser is located inside the door, next to the detergent dispenser.
To refill the dispenser, open the cap and pour the rinse aid into the dispenser until the
-
level indicator is fully lit. The volume of the rinse aid dispenser is approx. 140 ml.
Be careful not to overfill the dispenser too much, as this may cause sudsing. Wipe any
-
spills with a damp cloth. Do not forget to replace the cap before closing the dishwasher
door.
Warning!
Clean the spilled rinse aid with an absorbent cloth to avoid excess foaming during the next
wash.
BOLERO AGUAZERO 4201 E _4201 INOX E
76