Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting
1.) Unpack and check product for damage and completeness
2.) Mount the stand
!When mounting the speaker, there is a danger of crushing between the components!
3.) Mount the speaker on the stand
The stand is properly set up.
The stand must be placed on a level surface that can hold
the weight involved.
The cap of the flange bushing on the ROCKSTER AIR 2 is
open.
The »Ring Lock« is set to open and thus to the smallest
diameter.
Place the ROCKSTER AIR 2 on the »Ring Lock« from above 1.
The »Ring Lock« must be completely inserted into the flange
bushing.
Align the ROCKSTER AIR 2 in the desired position and secure
the speaker on the stand firmly and free of play by turning in
the close direction 2 on the clamping sleeve. By turning in the
open direction 3, the speaker is released again and can be
removed from the stand.
1 Accessory bag:
4x Rubber support
3x Countersunk screw M6 x 16 mm
1x Allen key SW4
2 Base
3 Base tube
Insert the base tube with the threaded
bolt into the base 1 and screw it with the
three countersunk screws 2.
NOTE: Make sure the indentations in
the base are facing down Z. The maxi-
mum tightening torque may not exceed
8 Nm.
Glue the four rubber supports to the
base as shown 3.
Publicidad
