LD Systems DIO 22 Manual De Usuario página 12

EXAMPLE DIO 22
The illumination of the characters is automatically deactivated if no input is made within
approximately 40 seconds .
EXAMPLE DIO 44
The illumination of the characters is automatically deactivated if no input is made within
approximately 40 seconds .
Edit mode: Press the encoder briefly and then select the desired channel by turning the encoder.
Now press the encoder for about 3 seconds to switch to editing mode. The channel number and
the abbreviation for phantom power P24V start flashing. Now switch the phantom power of
this channel on or off by turning the encoder (P24V flashes in sync with the channel number =
phantom power on, P24V flashes quickly = phantom power off). Confirm the selection by briefly
pressing the encoder. At the same time, the currently set value for GAIN now starts flashing and
you can change the value as desired by turning the encoder. Confirm the selection by briefly
pressing the encoder. The digit of the next channel then flashes and you can set the status and
value as desired or exit the editing mode by pressing the encoder again for about 3 seconds.
12