LD Systems DIO 22 Manual De Usuario página 19

DANTE® CONTROLLER
A Dante® network is set up using the freely available DANTE® CONTROLLER software. Download
the software from the manufacturer's website www.audinate.com and install it on a computer.
Connect the Ethernet interface of the computer to a network interface of the DIO 22 or DIO 44
using a network cable (Cat. 5e or better) and run the Dante® Controller software. The software
has an automatic device detection function. Signal routing is done by mouse click and the unit
and channel designations can be individually edited by the user. IP address, MAC address and
other information about the devices in the Dante® network can be displayed in the software.
Once the configuration of the devices on the Dante® network is complete, the Dante® Controller
software can be closed and the computer disconnected from the network. The settings in the
units in the network are retained.
When the DIO 22 or DIO 44 is disconnected from the Dante® network, the unit's audio outputs
are muted and the power icon on the front panel starts flashing.
19