Publicidad
PRODUCT SPECIFICATIONS
Maximum seating capacity:
Voltage / Frequency / Phase
Water capacity:
Inner/outer diameter:
Height:
Jet pump:
Bubble air blower:
Filter pump flow rate:
Heater power:
Temperature range:
Temperature rise:
Number of Water Jet Nozzles:
Number of Bubble Jets:
Spa tub recommended working air pressure:
RF frequency band: 2408~2476MHz
Inflatable, portable aboveground cord-connected spa with pump, heater, water jet, blower, control panel,
built-in hard water treatment, and sanitation
Note:
the spa equipment features a complete grounding system that is also in contact with the spa water. It
is possible that a person may build up static electricity that discharges when touching the water. Regardless,
any electric shock experienced should be investigated by a qualified electrician prior to use of the spa.
Unplug the spa until the cause is determined and any corrective action completed.
Hereby, Intex Development Company Limited, declares that this SC-20/SC-20N is in compliance with the
essential requirements and other relevant provisions of Derective 2014/53/EU.
Risk of fire: This product draws a minimum of 13 AMPS. Most household circuits are 13 to
16 AMPS. If the circuit breaker trips, please check that no other appliances or other large
loads are on the same circuit as the spa. Never use an extension cord. Unfold the line cord
prior to use. Never place the plug on combustible materials.
Site preparation and requirements
• The spa can be installed indoor or outdoor. For household use only.
• Make sure the area is water resistant, level, flat and free of sharp objects under or around the spa.
• Provide a properly located grounded electrical outlet with a protection grade of IPX4 or higher to connect
the spa and allow easy access for periodic testing of the cord mounted RCD.
• Make sure there is enough clearance around the spa for full access to the spa equipment for maintenance
and/or service.
• The area shall facilitate draining purposes during long term spa storage. Check local and national
regulations regarding spa water disposal requirements.
• To reduce noise disturbance, do not install the spa in the immediate vicinity of vertical walls.
• The area shall be within reach of fresh water supply in compliance with local water regulations, and whose
parameters shall be adjusted according to the spa water chemistry and balance section of the manual
before first use of the spa.
• Check your local laws and regulations regarding indoor and/or outdoor spa installation.
Additional requirements for indoor installation
• Make sure the floor can support the full weight of the filled spa with the maximum number of occupants.
Check with a qualified contractor or a structural engineer to verify this requirement.
• Make sure the floor is water resistant and non-slip surface. Do not install the spa on carpet or other
materials that will be damaged by moisture, condensation.
• Do not install the spa indoors on a second floor above finished living space due to the possibility of water
and humidity damage.
S AVE THESE INSTRUCTIONS
(344IO) SPA (JET + BUBBLE) ENGLISH 7.5" X 10.3" PANTONE 295U 08/09/2019
4 adults
220 – 240 V / 50 Hz / 1 PH
210 gal (795 L)
59/79 in (150/201 cm)
460 gal/hr (1,741 L/hr)
10ºC – 40ºC (50ºF – 104ºF)
1.5-2.5ºC/hr (3ºF – 4.5ºF/hr)
4
120
0.083 bar (1.2 psi)
Transmitter power: 10dBm
system.
WARNING
SET UP
English
6 adults
290 gal (1098 L)
66/86 in (168/218 cm)
28 in (71 cm)
1000 Watts
800 Watts
2,200 Watts
1-2ºC/hr (2ºF – 3.5ºF/hr)
6
140
Page 9
344
A
Publicidad
