HUANUO HNCM17 Manual De Instrucciones página 7

Secure the Monitor or Laptop Tray onto the Head of Swivel
Step 4
Arm
4-1 Slide the monitor onto the head of
Swivel Arm (d) as shown in the above
diagram.
Step 5 Adjustment
T
o
Medium
Allen Key
Tilt Adjustment
1. Directly tilt your Monitor to your desired
angle(if it is difficult to tilt the Monitor, for
better to tilt monitor you can slightly loosen
the nuts [T] using the Allen key).
2. Tighten the nuts [T] to hold the monitor in
place.
HEAVY! You may need
assistance with this step.
d
Note: Please refer the proce-
dures 4-1 and 4-2 to install
the laptop tray [t] with VESA
plate [e] onto the head of
swivel arm
4-2 Secure the Nut (h). Make sure the nut
is installed before you rotate the monitor.
Swivel Adjustment
1. Directly swivel your monitor to your desired
angle(if it is difficult to swivel the monitor, for
better to tilt Monitor you can slightly loosen
the nuts using the Allen key).
2. Tighten the nuts to hold the monitor in
place.
06
Wrench
3/8 in. (10mm)
(Not Included)
h
o
Medium
Allen Key