HUANUO HNCM17 Manual De Instrucciones página 8

Slightly Adjust the Height of each Monitor
If the monitor is lower, remove the nut [h] and turn the bolt counter-clockwise with
supplied Allen key [o] to raise the monitor. Install the nut [h] after the adjustment.
①
Remove the nut [h]
Step 6 Manage the Wires and Store the Allen Keys on Wire Clip
Warning:
To avoid tipping, please be
careful not to extend the arms
too far forward or backward.
When you adjust the angle of
the arms, please make sure
two arms are balanced to
avoid instability of the center
of gravity of the base.
②
Small Allen Key
ｏ
Use the Allen key [o] to slightly
adjust the height of each monitor
and re-tighten the nut [h] after
finishing height adjustment.
Individual monitor height adjust-
ment helps monitors to be
perfectly aligned.
07