Publicidad
Idiomas disponibles
Idiomas disponibles
6
www.electrolux.com
4
"Breeze" function key (Environment
ventilation)
The hood switches on at low suction
speed (power) for about one hour and
then switches off�
5
Display
Filter saturation indicator
At regular intervals, the hood warns when
the filters must be serviced.
Grease filter saturation indicator
The set speed and the letter "F" alternate
on the display�
Carbon filter saturation indicator
The set speed and the letter "C" alternate
on the display�
Reset of saturation indicator
In order to reset the saturation indicator,
switch on the hood then press and hold
button
1
Perform filter maintenance as
recommended in this manual�
In the event that both indicators of filter
saturation "F" and "C" start flashing,
proceed with the reset twice�
The saturation indicator of the charcoal
filter is not normally active and if the hood
is used in the recirculation mode, it must be
activated manually the first time.
Activation of the charcoal filter
saturation indicator:
Turn off the hood and simultaneously press
buttons
The letters "F" and "C" will flash on the
display for 2 seconds, to indicate successful
activation of the saturation indicator of the
charcoal filter.
Deactivation of the charcoal filter
saturation indicator:
Turn off the hood and simultaneously press
the buttons
letter "F" will flash on the display for 2
seconds, to indicate successful deactivation
of the saturation indicator of the charcoal
filter.
for about 3 seconds�
2
and
3
for 3 seconds�
2
and
3
for 3 seconds� Only
Temperature Alarm
The hood is equipped with a temperature
sensor which activates the motor at speed
3 in case the temperature in the display
zone is too high�
The alarm condition is indicated by the
display with the letter "t" flashing.
This condition remains as such until the
temperature falls below the alarm threshold�
This mode can be quit by pressing key "2"�
Every 30" the sensor checks the ambient
temperature of the display zone�
ood
5.1 Hob
H
2
The hood is equipped with a function for
wireless connection with the cooktop for
automatic adjustment of the most suitable
speed� Refer to the instruction manual of
the cooktop to verify the presence and
compatibility of this function�
In the case of first connection to the mains
or abrupt disconnection from power supply
(blackout), wait 1 minute to allow the hood
to restore the connection with the cooktop�
6. LIGHTING
The hood is equipped with a lighting system
based on LED technology�
The LEDs guarantee an optimum lighting,
a duration up to 10 times as long as the
traditional lamps and allow to save 90%
electrical energy�
Caution! Do not look directly into the
LED light�
To replace lights, contact authorised spare
part center�
Publicidad
