Publicidad
Idiomas disponibles
Idiomas disponibles
Pairing Remote
Synchronizing Two Foundat ions
The original remote that comes in the box is already paired to the foundation. No further action is required.
In the event when the remote is not paired with the foundation, follow the pairing instructions below.
PAIRING REMOTE
STEP 1：
Make sure the batteries are good.
Replace them when needed.
Unplug the power cord from the
STEP 2：
power source. If 9V backup
batteries were installed in the
power supply, remove them.
STEP 3：
Press and hold select buttons
and
until the LCD screen
of the remote control shows PAIR.
STEP 4：
Plug the power cord back
into the power source.
The LCD screen on the
remote control shows
"PASS", and you will hear
an activation sound in 2
seconds indicating the
remote is paired to the
power foundation.
If simultaneous operation of two foundations is desired, use the sync cord
STEP 1：Unplug foundations from the power source.
STEP 2：Connect the male ends of the sync cord to the female sync plugs of the control boxes (Refer to below illustration).
STEP 3：Plug foundations back into the power source.
STEP 4：Check to ensure all cords are securely attached.Either remote will operate both foundations simultaneously.
Press And
Hold
SYNCHRONIZING TWO FOUNDATIONS
to connect the electronics of both foundations together.
VOICE
Sync Plug
Customer Service Toll Free:
SETTING PROGRAMMABLE POSITION
STEP 1：
Adjust the head, foot and lumbar to your desired
position.
STEP 2：
Press and hold the LED button
seconds until the screen shows SAVE, then press
programmable buttons
hear a beep sound.
To save a new position, repeat step 1 and 2 and
STEP 3：
the new position will be saved.
BATTERY LEVEL
The battery icon in the upper-right conner
shows the battery level, replace the batteries
when the battery level is low.
Sync Cord
Sync Plug
1-800-248-5988
—07—
for about 5
or
, until you
Publicidad
