If the smart watch cannot be turned on after
being left unused for a long time, please clean
the metal charging pins with dry cloth to make
sure that they can connect properly.
8. WARRANTY
Each watch comes with a 2 YEAR LOCAL WARRANTY
against defects in materials and workmanship. This
warranty covers all parts except the battery, the strap
and the charging cable.
The following causes of defects are not covered by
the free warranty service:
1. Personal assembly or disassembly.
2. Damage caused by the watch being dropped
during use.
3. Any man-made damage or damage through the
fault of a third party, improper use (such as: water
in the smart watch, shattering due to external
forces, scratching during use etc.)
Please provide the warranty card with all details filled
in when you request aftersales services.
Please contact dealers directly for warranty services.
This limited warranty is void if the defect is discovered
to be caused by abuse or tampering with the watch.
TIPS
1. In order to ensure the waterproof performance of
the product, do not open the back cover of the
watch without authorization, and do not soak it in
hot water, hot tea or any corrosive liquids.
2. This product contains a lithium battery, please
make sure that you take it to a designated battery
recycling point for product recycling.
HydrogEl
SCrEEn
ProtECtor
ICE
smart
one
Installation Steps
Step 1:
Clean the watch screen with the cleaning cloth provided, and
remove dust by the dust remover.
Step 2:
Stabilize the watch on a flat surface by the ring provided.
Step 3:
Place the hydrogel film and align it to the watch screen, press
'←Position Line→' in the middle.
Step 4:
Lift
up to be over 90º to the screen. Press the squeegee evenly to
➀
stick the hydrogel film to the first half of the creen and remove the
base film at the same time from '←Position Line→' .
Step 5:
Do the same to the other half
. Scrape off excess bubbles by
➁
the squeegee.
Step 6:
Remove the surface film, smooth the edge if necessary.