Refill a Solvent and Empty Waste
Refill a Solvent and Empty Waste
Setup and Run a Purification
Refill a Solvent Reservoir
Refill a solvent reservoir by flipping up the sensor; see Figure 29
and Figure 30. This can be done at any time without pausing.
When the sensor is closed again, the amount of liquid available
in the reservoir is automatically updated in the software.
Figure 29. Push on the tube holder to be able to flip up (open) the sensor.
Figure 30. Refill a solvent reservoir at any time using a funnel.
Empty the Waste Reservoir
Always ensure that the system is idle or paused when emptying
the waste reservoir. Empty the waste reservoir by unscrewing
the whole liquid level sensor assembly; see Figure 31.
The run is automatically paused when the waste level is 95%
of the set capacity.
When the liquid level sensor assembly is attached to the
reservoir again (with the sensor closed), the amount of liquid
available in the reservoir is automatically updated in the
software.
14
Replace a Solvent or Waste Reservoir
Always ensure that the system is idle or paused when replacing
a solvent or waste reservoir. Either move the whole liquid level
sensor assembly to the new reservoir by unscrewing the cap
(see Figure 31) or detach the tube holder from the cap (see
Figure 32) and attach the assembly to the new reservoir using
a GL45 cap (P/N 418528SP) or a 38-430 cap (P/N 418529SP)
supplied by Biotage.
Note: When replacing the reservoir with another type of
reservoir, ensure to reassign the reservoir type in the Solvent
Setup view (see page 11).
Figure 31. Remove the whole liquid level sensor assembly by unscrewing
the cap. The cap rotates freely, independent of the attached tub holder
and sensor.
Figure 32. Detach the tube holder from the cap.
When the liquid level sensor assembly is attached to a reservoir
again (with the sensor closed), the amount of liquid available in
the reservoir is automatically updated in the software.
Biotage
Liquid Level Sensor for Biotage
®
Selekt Family – User Manual | © Biotage 2023
®