Publicidad
Connect the Liquid Level Sensors to the System
Prepare the System
Warning
»
Read and follow the safety requirements on page 4.
Connect the Hub to the System
1. Ensure that the system is turned off.
2. Slide the hub into position between two rails on the right
side of the system; see A in Figure 2. It is recommend that it
is placed into the bottom rail.
3. Connect the CAN power cable supplied with the liquid level
sensor kit between the CAN IN port on the hub and the AUX
port at the rear of the system; see B in Figure 2.
Note: If the AUX port is plugged, remove the plug.
A
A
Figure 2
. Connecting the liquid level sensor hub to the system.
Mount the Liquid Level Sensors
on the Reservoirs
Note: Only reservoirs with the GL45 or 38-430 neck thread are
currently supported. An universal cap adapter that may be used
for other reservoirs can be ordered separately; see "Use the
Universal Cap Adapter" on page 7.
1. Attach a GL45 cap (P/N 418528SP) or a 38-430 cap
(P/N 418529SP) to the reservoir; see Figure 3.
Figure 3. The GL45 and 38-430 caps that can be used with the liquid level
sensor kit.
B B
Connect the Liquid Level Sensors to the System
2. Attach the solvent inlet/waste outlet tube to the tube
holder; see Figure 4. Two tube inserts are required to attach
the waste tube.
A
A
Figure 4
. A: Two tube inserts are required for the waste outlet tube.
B: The waste outlet tube attached to the tube holder.
3. Snap the tube holder onto the cap as shown in Figure 5.
Figure 5. Attach the tube holder to the cap.
4. Adjust the position of the tube by gently sliding it up or
down the tube holder groove:
»
Solvent reservoir: Ensure that the solvent inlet filter
is at the bottom of the reservoir and that the filter
and tube will not block the sensor's line of sight
to the bottom of the reservoir; see Figure 6.
»
Waste reservoir: Ensure that the end of the waste
outlet tube is positioned at the bottom of the reservoir
and that the tube will not block the sensor's line of
sight to the bottom of the reservoir; see Figure 6.
A
A
Figure 6
. A: Ensure that the solvent inlet filter, or the waste outlet tube, is
at the bottom of the reservoir. B: Ensure that nothing is blocking the
sensor's line of sight to the bottom of the reservoir.
B B
B B
5
Publicidad
