1
2
3
4
Head Support
1
Lower Back Support
2
Armrest
3
Base
4
Cupholders
5
Head Support Adjustment Lever
6
Shoulder Belt Guide
7
ISOFIX Connector
8
Instruction Manual Storage
9
ISOFIX Guides
10
5
7
IMPORTANT
EN
READ THESE INSTRUCTIONS
CAREFULLY BEFORE USE AND KEEP
THEM FOR FUTURE REFERENCE.
6
YOUR CHILD'S SAFETY MAY BE
AFFECTED IF YOU DO NOT FOLLOW
THESE INSTRUCTIONS.
7
WARNING:
IMPORTANT, RETAIN FOR FUTURE
REFERENCE: READ CAREFULLY.
NO booster can guarantee full
protection from injury in an accident.
However proper use of this booster
will reduce the risk of serious injury or
death to your child.
8
Always take care to follow the
installation instructions correctly, this
will ensure the booster performs at
an optimum safety level.
Do take care so that the rigid items
and plastic parts of an booster shall
9
be so located and installed that they
are not liable to become trapped by
a moveable seat or in a door of the
vehicle.
To use this booster seat according
to the ECE R129/03, your child must
meet the following requirements.
10
Child height 100cm-150cm
(reference age: 3.5-12 years).
Forward facing only (in vehicle travel
direction)
The enhanced child restraint may not
fit in all approved vehicles.
Any straps holding the booster to
,
the vehicle should be tight
that any
straps restraining the child should be
adjusted to the child's body, and the
straps should not be twisted.
The booster seat should be replaced
if it has been subjected to heavy
loads in the event of an accident or if
it has been dropped.
This booster seat is only intended to
be used in the car.
Do not make any alterations or
additions to the booster seat without
approval from the type approval
authority. DO NOT remove any of the
white EPP/EPS foams. Failure to do so
may result in serious safety issues.
DO NOT use the seat if the surfaces
are too hot from sunlight.
Never leave the child unattended in
the booster seat or vehicle, not even
for a few minutes.
Any luggage or other objects liable
to cause injuries in the event of a
collision shall be properly secured.
The booster shall not be used
without the soft goods.
The booster soft goods should not be
replaced with any other than the one
recommended by the manufacturer,
because the soft goods constitutes
an integral part of the restraint
performance.
8