Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
7. Base unit
8. Spindle lock button
9. Locking lever
10. Locking lever adjustment nut
11. D-shaped subbase
12. Dust extraction system attachment accessory
13. Thumb screw
14. Motor release lever
Assembly
Warning! Before assembly, remove the battery from the tool.
Charging the battery (Fig. A)
The battery needs to be charged before fi rst use and
whenever it fails to produce suffi cient power on jobs that were
easily done before.
The battery may become warm while charging; this is normal
and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging
temperature: approx. 24 °C.
Note: The charger will not charge a battery if the cell
temperature is below approximately 10 °C or above 40 °C.
The battery should be left in the charger and the
charger will begin to charge automatically when the cell
temperature warms up or cools down.
Note: To ensure maximum performance and life of lithium-ion
battery packs, charge the battery pack fully before fi rst use.
Plug the charger (15) into an appropriate outlet before
inserting battery pack (1).
The green charging light (15a) will blink continuously
indicating that the charging process has started.
The completion of charge will be indicated by the green
charging light (15a) remaining ON continuously. The
battery pack (1) is fully charged and may be removed and
used at this time or left in the charger (15).
Charge discharged batteries within 1 week. Battery life will
be greatly diminished if stored in a discharged state.
Charger LED Modes
Charging:
Green LED Intermittent
Fully Charged:
Green LED Solid
Hot/Cold Pack Delay:
Green LED Intermittent
Red LED Solid
26 26
(Original instructions)
Note: The compatible charger(s) will not charge a faulty
battery pack.
The charger will indicate a faulty battery pack by refusing to
light.
Note: This could also mean a problem with a charger. If the
charger indicates a problem, take the charger and battery
pack to be tested at an authorized service centre.
Leaving the battery in the charger
The charger and battery pack can be left connected with the
LED glowing indefi nitely. The charger will keep the battery
pack fresh and fully charged.
Hot/Cold Pack Delay
When the charger detects a battery that is too hot or too
cold, it automatically starts a Hot/Cold Pack Delay, the green
LED (15a) will fl ash intermittently, while the red LED (15b)
will remain on continuously, suspending charging until the
battery has reached an appropriate temperature. The charger
then automatically switches to the pack charging mode. This
feature ensures maximum battery life.
Battery state of charge indicator (Fig. B)
The battery includes a state of charge indicator to quickly
determine the extent of battery life as shown in fi gure B. By
pressing the state of charge button (1a) you can easily view
the charge remaining in the battery as illustrated in fi gure B.
Installing and Removing the Battery Pack from the
tool
Warning! Make certain the lock-off button is engaged to
prevent switch actuation before removing or installing battery.
To install battery pack (Fig. C)
Insert battery pack (1) fi rmly into tool until an audible click
is heard as shown in fi gure C. Ensure battery pack is fully
seated and fully latched into position.
To remove battery pack (Fig. C)
Depress the battery release button (2) as shown in fi gure
C and pull battery pack out of tool.
Assembly and adjustments
Warning! To reduce the risk of serious personal injury,
turn unit off and remove the battery pack before making
any adjustments or removing/installing attachments or
accessories. An accidental start-up can cause injury.
Publicidad
