Publicidad
Idiomas disponibles
Idiomas disponibles
• This heater can be installed on feet (provided) or on a wall (fixings provided).
• The heater must never be installed underneath a mains wall socket.
• The heater must never be installed in a position where the switches and other controls can
be reached by someone in the bath or shower.
• The heater works through natural air convection. In order to achieve correct performance
and uniform heat distribution, when it is installed on a wall the lower part of the heater
must be a minimum of 20 centimetres from the floor, a minimum of 20 centimetres from the
sides, 50 centimetres from an upper shelf and also a minimum of 20 centimetres from any
wall or object (furniture and curtains etc).
1. Select a suitable location on the wall, which should be firm and level. Check that there is a
mains socket close by.
2. The distances vary depending on the heater model.
3. Open the package box and check that all fixing accessories are present, it is a good idea
to keep the product box for storing out of season.
A
B
1. While respecting the previously indicated safety
measurements, make two marks on the wall according
to measurement "e" indicated in Table 1 and at a height
of 695 mm from the floor (not from the skirting board).
2. At the marked area drill two 10 mm diameter holes, with
a minimum depth of 60 mm.
3. Push the two plugs (D) into the two holes and secure
the two hooks (C) with the two screws (D).
E NGL I SH
8
INSTALLATION AND MOUNTING
WALL INSTALLATION
C
ASSEMBLY
D
E
Skirting board
Shelf
Object
F
Publicidad
