Publicidad
Check that the tool and the batteries are
clean and dry and then insert the battery in
the appropriate seat of the scissors.
5. CONTROLS
5.1 ON / OFF SWITCH (FIG. 1 L)
•
Activate the machine
•
select the blade opening
5.2 TRIGGER BUTTON (FIG. 1 E)
•
Activate the movement of the blade
5.3 LOCK/UNLOCK LEVER (FIG. 1 D)
•
Prevents or enables the activation of the
trigger.
6. USING THE MACHINE
The safety regulations to follow are
described in chap. 2. Strictly comply with
these instructions to avoid serious risks or
dangers.
IMPORTANT For instructions regarding the the
battery read the relevant manuals.
6.1 PRELIMINARY PROCEDURES
Before starting to work, it is necessary to carry
out several checks and operations to ensure you
can work efficiently and in maximum safety.
6.1.1 Checking the battery
Purchase the battery with the capacity that most
suits your operational requirements and fully
charge it according to the instructions in the
battery booklet.
The list of approved batteries for this machine is
found in the "Technical Data" table (sheet ii).
• Before each use:
– check the battery charge status according
to the instructions in the battery booklet.
6.1.2 Control of the ON / OFF switch
Check the correct operation of the ON / OFF
switch.
The blade must stop when the trigger is
released.
6.2 SAFETY CHECKS
Run the following safety checks and check that
the results correspond to those outlined on the
tables.
Always carry out the safety checks before
use.
Object
Grip and guards
Screws on the
machine and blade
Protections
Battery
Machine
ON/OFF switch,
trigger button, lock/
unlock lever
Test driving
6.3 START-UP AND WORKING
1. Remove the blade protection cover (Fig. 3 A)
2. Press the ON / OFF switch
(Fig .3 B) for 2seconds.
3. After the beep,
4. act on the lock/unlock lever (Fig .3 C) and
press the trigger to activate the blades (Fig.
3 D)
5. Pressing the trigger the blade closes,
releasing the trigger the blade opens (Fig. 4)
6. Put the blade on the branch to be cut (Fig. 5)
Release the trigger if the blade is
blocked, the blade will automatically return to
the maximum opening position.
If left unused for 1 minute, the scissor
goes automatically to power off.
EN - 6
Result
Clean, dry, without
traces of oil and
grease, and fixed
correctly and firmly
to the machine.
Correctly tightened
(not loose)
Intact, undamaged.
No damage to
the casing, no
liquid leakage
No signs of
damage or wear
All the controls must
move freely and
not be forced.
No abnormal
vibrations.
No abnormal sound
Publicidad
