Publicidad
7.2.3 Refitting the battery on the machine
When recharging is completed:
1. Remove the battery from the housing in the
battery charger (do not keep charging when
recharging is completed).
2. Disconnect the battery charger from the
electrical outlet.
3. Insert the battery into its housing on the
machine.
4. Push down the battery all the way until
you hear a " click" that locks it in place and
guarantees the electrical contact.
7.3 CLEANING
7.3.1 Cleaning the tool
After every work session, clean the machine
thoroughly to remove all dust and debris.
• Always clean the machine after use with a damp
cloth dipped in neutral detergent.
• Remove all traces of humidity using a soft damp
cloth. Humidity can generate risks of electric
shocks.
• Do not use aggressive detergents or solvents to
clean the plastic parts or hand grips.
• Do not spray water onto the motor and electrical
components and prevent them from getting wet.
• To avoid overheating and damage to the motor
or the battery, always keep the cooling air vents
clean and free of debris.
8. OCCASIONAL MAINTENANCE
To sharpen and replace the blades,
contact your dealer or a specialized center.
9. STORING
9.1 STORING THE TOOL AND
THE BATTERY
1. Remove the battery from its seat and recharge
it;
2. Avoid storing the device in extremely hot or
cold environments.
3. Batteries and chargers must be placed in a
dry and safe place to prevent the entry of heat,
dust and humidity.
4. Store the tool in a place where children cannot
get to it
5. making sure that keys or tools used for
maintenance are removed.
10. ASSISTANCE AND REPAIRS
This
manual
information to run the machine and for correct
basic maintenance operations which can be
performed by the user. Any regulations and
maintenance operations not described herein
must be carried out by your Dealer or Authorised
Service Centre, which have the necessary
knowledge and equipment to ensure that the
work is carried out correctly, maintaining the
correct degree of safety and the original operating
conditions of the machine.
Any operations performed in unauthorised centres
or by unqualified persons will totally invalidate the
Warranty and all obligations and responsibilities
of the Manufacturer.
• Only authorised service centres can carry out
guaranteed repairs and maintenance.
• The authorised service centres only use
genuine spare parts. Genuine spare parts and
accessories have been designed specifically for
machines.
• Non-genuine spare parts and accessories are
not approved. Use of non-genuine spare parts
and accessories cause the warranty to be
invalidated.
• It is advisable to send your machine once a year
to an authorised service centre for servicing,
assistance and safety device inspection.
11. WARRANTY COVERAGE
The warranty covers all material and manufacturing
defects. The user must follow all the instructions
provided in the accompanying documentation.
The warranty does not cover damages caused by:
• Failure
to
documentation accompanying the machine.
• Carelessness.
• Incorrect or prohibited use or assembly.
• Use of non-genuine spare parts.
• Use of accessories not supplied or approved by
the manufacturer.
The warranty does not cover:
• Normal wear and tear of consumables, such as
cutting means, safety bolts.
• Normal wear and tear.
The purchaser is protected by his or her own
national legislation. The purchaser's rights under
the national laws or his or her own country are not
in any way restricted by this warranty.
EN - 8
provides
all
the
become
familiar
necessary
with
the
Publicidad
