HTW -VP-40FS Manual De Usuario página 15

PEDESTAL FAN HTW-VP-40FS
ASSEMBLE GRILL
1. Unscrew the spinner clockwise and the plastic nut counterclockwise to remove both of them. Fix
the rear grill so it sits perfectly flush to the motor then tighten the plastic nut clockwise. (see Fig. 5)
2. Insert the blade into shaft, and make sure the rotor shaft pin is fitted into groove of the blade. Turn
the spinner counterclockwise to tighten the blade. (see Fig. 6)
3. Fasten the front grill and the rear grill to each other by using the grill clips.
Fig.5
ASSEMBLE PEDESTAL STAND AND BASE
4. Assemble the cross base and remove the 4 fasteners Fix the pole on the cross base and refit the 4
fasteners and tighten.Drop the base cover over the cross base
5. Loosen the Height adjustable locking ring and extend the support pole to your desired height (note :
the metal pole may have sunk into the metal body occasionally ,simply unscrew the locking right .tip
the pole up side down and you will find it )
6. Retighten the height adjustable lock ring to prevent slipping
7. Take the fan assembly and place it onto the pole and tighten the pole screw by hand.
Spinner Spinner
Tight
Loose
Plastic nut
Fig.6
Tight
Slot
Retaining
Blade
Pin
USER MANUAL
ASSEMBLE
Fig.7
Clip
15
