Descargar Imprimir esta página

Hamilton Beach Brita Hub Manual página 8

Publicidad

Idiomas disponibles

Idiomas disponibles

How to Dispense Filtered Water
1.
Plug into outlet.
How to Reset Filter Life
Replacing Filter before end of life (green or yellow light on
during use):
If you need to replace the Filter before the indicator is red, the
indicator will need to be manually reset. After installing the
new Filter, press ( ) Dispense Button 4 times. This will reset the
indicator, and the Indicator Light will turn green.
If water flows too slowly but the Indicator Light is still green or
yellow, you may have poor water quality (e.g. sediment, sand,
rust, etc.) that requires more frequent filter replacement to
maintain the desired flow rate.
8
2.
Place your glass or bottle on
Drip Tray.
3.
Press and hold ( ) Dispense Button to activate pump to dispense
desired amount of water. When Button is released water flow will
stop. Do not remove cup until pump turns off.
4.
OR press ( ) Dispense Button 2 times to continually dispense water.
Press Button again when desired amount of water has dispensed. Do
not remove cup until pump turns off.
If you're replacing your Filter at or past its useful life (red light is
on or flashing):
Remove used Filter and replace with new Filter. When new filter is
installed, the indicator will automatically reset and Indicator Light
will turn green. It's that easy.
NOTE: Remember to flush new Water Filter according to
directions on page 7.
OR

Publicidad

loading