Publicidad
Idiomas disponibles
Idiomas disponibles
To operate the throttle control and
the stop switch (590BFS)
•
Apply full throttle (A).
•
Apply idle speed (B).
•
Stop the product with the stop switch (C).
C
To operate the throttle control
(590BTS)
•
To increase the blower speed during operation,
push the throttle control until you get the correct
speed.
•
To decrease the blower speed during operation,
release the throttle control until you get the
correct speed.
To operate the stop switch
with throttle position adjustment
(590BTS)
The stop switch with throttle position adjustment (A)
lets you set the blower speed without the throttle
control.
1805 - 004 - 20.11.2023
•
A
B
•
•
To start the product
1. Set the throttle to the position for idle speed.
2. Push the air purge bulb again and again until fuel
3. Push the start button down fully until it locks in
4. Put the product on a flat surface on the ground.
To increase the set blower speed during
operation, push the stop switch (A) up.
To decrease the set blower speed during
operation, push the stop switch down.
To stop the product, push the stop switch down
fully.
590BFS
starts to fill the air purge bulb. It is not necessary
to fill the air purge bulb fully.
position.
Note:
If the throttle is not set to idle speed, the
start button does not lock in position.
A
590BTS
15
Publicidad
