Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS ( CONTINUED )
Figure 2
Figure 4
24" - 40" Extension Pipe
Install Pump on Tank
1.
Clean the tank interior of all dirt and foreign material.
2.
Carefully lift pump / suction pipe assembly and insert suction pipe into the
tank opening.
While holding the spin collar gasket in place, position the pump spin collar onto
the tank adapter and tighten using a pipe wrench, making sure the spin collar is
not cross-threaded (see Figure 7); The spin collar measures 2.26 inches (57.40
mm) across flats.
NOTE: To prevent pressure buildup and possible fuel leaks, make sure the
fuel tank is properly vented. A vent cap rated at 3 psi (20.68 kPa) or less is
recommended.
Figure 7
8
EN
Figure 3
Figure 5
15" - 24" Telescoping Suction Pipe
Figure 6
Publicidad
