Nolangroup N-Com X Serie Seguridad E Instrucciones página 58

EN
Pairing up of CHANNEL 1
Pairing up of CHANNEL 2
Pairing up of CHANNEL 3
N.B.: In case there are already other intercom systems stored in the memory of the B902 system, check
on the EASYSET N-Com App which channels are still available. If a channel that is already used is
selected during pair up, the new intercom system will overwrite the one previously stored on that
channel.
•
After a few seconds, Intercom B will emit the confirmation beep.
18.2. Universal Intercom Function
To turn on and off the audio between two helmets, proceed as follows:
From the N-Com B902 system:
Connect or disconnect Intercom B as you would for a regular N-Com intercom (chapter 17.3).
Intercom B may receive a dialling tone that must be answered with a phone reply command.
From intercom B
To enable the intercom connection, press the "
To disable the intercom connection, press the "
N.B.: Some systems are not able to handle the activation / deactivation of the intercom connection. In
this case, operate from the B902 system.
N.B.:
•
During use of the UNIVERSAL INTERCOM, the B902 system keeps the connection active to the
MAIN DEVICE only (and not to the SECOND MOBILE PHONE or to the SATELLITE NAVIGATOR).
•
The intercom system connected to N-Com B902 may not allow simultaneous connection to a
mobile phone.
•
Only one system paired up in Universal Intercom mode can be stored.
Universal Conference
18.3.
The "Universal Conference" mode can be used to connect in conference call N-Com systems of the
"900" series and one system paired up in Universal Intercom mode.
The connection procedure is outlined in the diagram provided here below:
1. System A must have been paired up beforehand to two B systems (Universal Intercom pair
up) and C.
2. System A has to initiate the first intercom connection with system B (Universal Intercom), by
pressing the relative intercom connection command.
26
Briefly press key "n".
Press 2 times key "n".
Press 3 times key "n".
Voice Call
Hang up
(chain intercom)
Last number redial
" or "
Reject phone call
" or "
" command.
" command.