Publicidad
Idiomas disponibles
Idiomas disponibles
TOP CONTROL PANEL
6
1 BALANCED AUDIO INPUT
Input on an XLR-F connector for the line level balanced signal from the subwoofer.
2 OUTPUT LINK
Balanced output on an XLR-M connector to connect another speaker/system in parallel.
3 DATA IN
EtherCON
/RJ45 input for the RDNet network signal from the Nettuno 50 subwoofer.
®
4 DATA OUT
EtherCON
/RJ45 output to link the network signal to another speaker/system.
®
5 RDNET MONITOR LEDS
The LEDs monitor RDNet module operation. In particular:
"Link" illuminates to indicate that the RDNet network is active and has recognised
„
the device
"Active" flashes to indicate the presence of data traffic
„
"Remote Preset Active" comes on to warn that all local controls on the amplifier
„
panel are bypassed by the RDNet remote control or by a "User" memory, which can
be loaded by pressing the "User" button.
6 USB SERVICE DATA
Standard type-B USB port for updating the product firmware. For further information,
refer to the UPDATING THE FIRMWARE chapter
3
4
6
RDNet
USB Data
Data In
Data Out
Service
Link Active
Remote
Active
Balanced Audio
Limiter
Input
Output
Signal
Link
Status
ON
PRESET
1
2
8
7
3
4
6
5
PRESET
Single System
Double System
1 = HPF
5 = HPF
OFF
2 = HPF + HFC
6 = HPF + HFC
3 = Full Range
7 = Full Range
ON
4 = Full Range + HFC
8 = Full Range + HFC
USER/
SERVICE
2
9
1
user manual
5
7
8
29
Publicidad
