Seko POOLDOSE DOUBLE Manual De Instrucciones página 12

PoolDose | pH · ORP · Chlorine
Set menu:
Press (3 seconds) and adjust set point value and press SET to confirm.
Free Chlorine
measure
pH
measure
Calibration Menu:
Press (3 seconds) and calibrate probe pH, Chlorine, Temperature, ORP,
StandBy system
Press (5 seconds) the system sets in StandBy mode; all functions are disabled.
Reset OFA Timer
Press (click) and reset countdown OFA time
Priming pumps
Only while the pump is in "stand-by mode" press down
to run ORP/Chlorine pump, press
To restore the default parameters, follow the steps below:
• Power off the PoolDose unit
• Keep
and
• The unit will flash
Init.default__Yes
• Press
• Press
to restore the default parameters.
Default parameters:
• Language = EN
• Set Point value = 7.4 pH; 700 mV; 1.2 ppm
• Dosing method = Acid
• OFA Time = OFF
• Calibration = Full
• Flow Input = OFF
• Dosing type = PROP; ON/OFF Relay Aux1 e Aux2
0000138994
1.2 ppm
7.4 pH
to run the Aux1 Relay, press
pressed and power on the unit
Init.default__no
; Low
(pH) (Redox)
rev. 1.1
SetPoint
720mV
to reset flow totalizer,
to run the Aux2 Relay.
EN
Quick setpoint menu
ORP
measure
to run pH pump, press
10