Seko POOLDOSE DOUBLE Manual De Instrucciones página 8

PoolDose | pH · ORP · Chlorine
§
§
§
§
§
§
§
§
§
§
§
§
§
Note: Timeout setting menu, after 120 seconds without action the controller escape itself without saving parameters.
View Parameters
Free Chlorine Measure
Alarms
Lev CL
OFA CL
Temperature or Totalizer
Flowrate measure,
Moreover:
Alarms sharing messages
• Circ. Pump OFF
• Flow (Reed OFF)
• WiFi OFF
• Remote standby
deletes all measures
Calibration Menu:
Press (3 seconds) and calibrate probe pH, Chlorine, Temperature, ORP
0000138994
Calibration CL: 2 points, Disable,
Calibration Temp: Reference, Disable,
Dosing Type pH: Proportional, OFF, Timed, On/OFF
Dosing Type ORP: Proportional, OFF, Timed, On/OFF
o Note: The ORP dosing is disabled if Dosing type chlorine is different than
OFF
Dosing Type Chlorine: Proportional, OFF, Timed, On/OFF
Aux Relay
• Aux1 Relay: pH, Disable
• Aux2 Relay: Chlorine, ORP, Disable
o Note: Aux1 and Aux2 relays dose with ON/OFF method
Password: 0000 (Note: password disabled, set a value other than: 0000)
Reset Calibration: (Note: select the measure to reset: pH; Chlorine; ORP)
Reset All Parameters
PROG Control Panel: displays the electrical signals
display error, when red): NO/NC
Reed
(
Power ON Delay: Disables the dosing pumps for the set time
Flow Delay: Disables the dosing pumps for the set time
1.4ppm
25°C
rev. 1.1
7.4pH
720mV
EN
pH
measure
Alarms:
Lel pH
OFA CL
ORP
Measure
Alarms:
Lev CL(ORP)
OFA ORP
6