Publicidad
Idiomas disponibles
Idiomas disponibles
Install a wall bracket
•
Choose a place near an electrical outlet.
•
The height should be sufficient so that the brush tube hangs
freely.
•
Place the bracket on the wall and use a pencil to mark the
holes to be drilled.
•
Drill holes and insert wall plugs. Put the bolts through the
holes in the handle and tighten.
Attention:
The location of the handle should be away from potential sources of
high and low temperatures, such as a radiator.
Charge the battery and store accessories
•
Hang the assembled vacuum cleaner on the wall bracket.
•
Plug the charger into an electrical socket and then into the
charging socket on the handheld vacuum cleaner.
•
Place the accessories in the appropriate places on the wall
bracket.
Battery indicators show the charge level.
•
When fully charged, the indicators stop flashing.
•
Fully charge the battery before first use. This may take 46
hours. Duration: At maximum power: approx. 15 minutes. At
lowest power: approx. 30 minutes The operating time of the
vacuum cleaner may vary depending on the brushes used and
the conditions of use.
Operation
•
Press ON/OFF to start the appliance.
•
Press ON/OFF again to turn off the appliance.
•
Press the "Mode Change Button" to change the mode.
•
Charge the appliance when only one power indicator flashes.
EN
Mode change button
CLEANING AND CARE
Empty the dust bin
Instructions:
•
To maintain the suction power of the vacuum cleaner, empty
the dust bin regularly.
•
Press the release button, open the bottom cover and dispose
of the dust.
Use the vacuum cleaner and accessories
•
Always turn the vacuum cleaner off before attaching acces-
sories.
Cleaning and maintenance
•
Press the dust bin release button and remove the bin.
•
Remove the filter from the dust bin.
•
Dismantle the filter and clean it. All parts of the filter are
washable.
•
When all parts are cleaned, reassemble them in the reverse
order.
Electric brush cleaning and maintenance
Note!
In order to ensure proper operation of the brush, regularly clean
the brush roller and wheels from dust and tangled hair and threads.
Make sure the appliance is turned off before removing the main
brush. Press the release button and remove the brush. Open the
brush cover, then remove and clean the brush roller. After cleaning
the roller, replace it in the reverse order.
Note! Figures are for illustrative purposes only Individual models
may vary.
8
ON/OFF power button
Publicidad
