Descargar Imprimir esta página

Ryobi RC18180 Traducción Del Manual Original página 7

Publicidad

Make sure that the battery pack latch clicks into place
and that the battery pack is secured in the charger
before charging.
NOTE: The charging times listed on the compatible battery
packs table can vary depending on the type of the battery
pack used (e.g., RB18L40, RB1840X, RB1840T).
NOTE: When the battery becomes fully charged, the
green LED remains on. It is normal for the battery pack
to become slightly warm to touch while charging.
NOTE: When charging, the charger and battery pack should
be placed in a location where the temperature is more than
10 °C but less than 25 °C.
CHARGING A COOL BATTERY PACK
1. Insert the battery pack into the charging port. Make sure
that the battery pack latch clicks into place.
2. Connect the product to a power supply.
3. Disconnect the product from the power supply when the
battery pack becomes fully charged.
4. Press the battery pack latches to unlock the battery pack
from the product.
5. Remove the battery pack from the product.
CHARGING A HOT BATTERY PACK
When using a tool continuously, the cells in the battery pack
become hot. A hot battery pack should be allowed to cool
down for approximately 30 minutes before recharging.
MAINTENANCE
When not using or when cleaning the product, disconnect
it from the power supply and remove the battery pack.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents. Use a clean cloth or soft brush to remove dirt
and dust.
Do not, at any time, let brake fluids, gasoline, petroleum-
based products, and penetrating oils come in contact
with plastic parts. These products contain chemicals that
can damage, weaken, or destroy plastic.
Hazardous voltages are present within the product; do
not disassemble.
CLEANING THE CHARGER
Unplug the charger power cord from the power supply
before cleaning to prevent serious personal injury.
Clean the charger surface (except labels) using a damp
cloth with a mild detergent.
Do not use any strong detergents on the plastic housing.
They can be damaged by certain aromatic oils, such as
pine and lemon, and by solvents such as kerosene.
Moisture can cause a shock hazard. Wipe off any
moisture with a soft, dry cloth.
STORAGE
Store the product in a cool, dry place between 10 °C
and 38 °C.
KNOW YOUR PRODUCT
See page 84.
1. LED indicators
2. Battery port
3. USB charging port
4. Wall mounting holes
5. Operator's manual
6. Battery pack
SYMBOLS
Direct current
Alternating current
Class II equipment
Please read the instructions carefully before
starting the product.
For indoor use only.
Time-lag fuse 5A
Do not dispose of waste electrical and
electronic equipment as unsorted municipal
waste. Waste electrical and electronic
equipment must be collected separately.
Waste light sources have to be removed
from the equipment. Check with your local
authority or retailer for recycling advice
and collection point. According to local
regulations, retailers may have an obligation
to take back waste electrical and electronic
equipment free of charge. Your contribution
to the reuse and recycling of waste electrical
and electronic equipment helps to reduce
the demand of raw materials. Waste
electrical and electronic equipment contain
valuable and recyclable materials, which
can adversely impact the environment and
the human health if not disposed of in an
environmentally compatible manner. Delete
personal data from waste equipment, if any.
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL
7

Publicidad

loading

Este manual también es adecuado para:

51330062625133006263